RT 2020-Present Under Glow
Step 1: Installing LED Controller unit:
- a) Remove three panels on the right hand side. Maintenance access panel, lower cover and top cover
- b) Locate and disconnect the DRL LED power connector
- c) Connect the female Power adapter into the male connector on the Spyder
- d) Connect the male Power adapter into the female connector on the Spyder
- e) Connect the black barrel connector (red and black wires) to the white barrel connect on LED controller
- f) If installing only one LED accessory, skip to Step 2.
- g) If connecting more than one LED accessory, connect the 4 into 1 “Y” connector to the LED Controller.
Step 2: Under Glow LEDs Installation:
Note: The under glow LEDs are mounted in the center of the 4” x 35” flat frame piece
- a) Clean and degrease center frame surface area with Isopropyl Alcohol.
- b) Apply the adhesive activator to the area where the LEDs will be mounted and let dry.
- c) Check fit before removing the protective tape
- d) Apply the adhesive activator to the area where the LEDs will be mounted and let dry.
- e) With the connectors facing the front of the Spyder, remove the protective tape from the back of the LEDs and mount them to the frame.
- f) Connect the extension wire to the LED Underglow connector and feed it back up to the LED Controller unit.
- g) Connect the extension wire to the LED Controller unit or to the 4 into 1 “Y” connector at the LED controller
- h) Remove the passenger seat
- i) Connect the extension cable to one of the connections of the 2 into 1 Y connector.
- j) Route the extension cable through the driver seat hinge opening
- k) Clean surface area with Isopropyl Alcohol.
- l) Check fit before removing the protective tape
- m) Apply the adhesive activator to the area where the LEDs will be mounted and let dry.
- n) With the connectors facing the front of the Spyder, remove the protective tape from the back of the LEDs and mount them to the bottom of the saddle bag (black plastic)
- o) Connect extension cable to LED connector
- p) Repeat steps (i) – (o) for the other side.
- q) Connect two extension cables together and then connect to the single connector on the 2 into 1 Y connector
- r) Run the wire along the right side under the plastic towards the front of the Spyder.
- s) Connect to LED control unit
- t) Verify LED lights work.
- u) Clean surface area with Isopropyl Alcohol.
- v) Check fit before removing the protective tape.
- w) Apply the adhesive activator to the area where the LED will be mounted and let dry.
- x) With the connector at the top, remove the protective tape from the back of the LED and mount to the plastic panel.
- y) Route the wire behind the black fin and up through the opening
- z) Connect an extension cable and route up to the area under the maintenance panel behind the frunk to a “y” connector.
- aa) Repeat steps u) – z) for other side.
- bb) Connect the “Y” connector to the LED Controller unit.
- cc) Verify LED lights work.
- dd) Tidy up the wires and reassemble Spyder.
If you have any questions please contact Spyder Dan