RT 2020-Present Halo Wheelz

Step 1: Installing LED Controller unit:

  • a) Remove three panels on the right hand side. Maintenance access panel, lower cover and top cover
  • b) Locate and disconnect the DRL LED power connector
  • c) Connect the female Power adapter into the male connector on the Spyder
  • d) Connect the male Power adapter into the female connector on the Spyder
  • e) Connect the black barrel connector (red and black wires) to the white barrel connect on LED controller
  • f) Place the LED controller under the maintenance access panel at the back of the Frunk.
  • g) If installing only one LED accessory, skip to Step 2
  • h) If connecting more than one LED accessory, connect the 4 into 1 “Y” connector to the LED Controller.

Step 2: Installing Halo Wheelz. The Halo Wheelz are mounted to the two bolts at the upper and lower A-Arms.

  • a) Remove front tire.
  • b) Remove the two 13mm bolts that hold the fender bracket on to the A-Arm. This will give you access to the  upper A-Arm bolt.
  • c) Loosen the two 15mm bolts and nuts, ONLY REMOVE ONE BOLT AT A TIME.
  • d) Pig tail wire (end of LED light strip) are on the top side of the Halo Wheelz
  • e) Remove the upper bolt, Align the Halo Wheelz mounting hole with the hole you just removed the bolt from on  the Spyder. Reinsert the bolt through the bolt hole on the Halo Wheelz and the Spyder and attach the nut. You  may need to move the ball joint up or down slightly to get the bolt inserted. Hand tighten the nut.
  • f) Remove the lower bolt, Align the Halo Wheelz mounting hole with the hole you just removed the bolt from on  the Spyder. Reinsert the bolt through the bolt hole on the Halo Wheelz and the Spyder and attach the nut. You  may need to move the ball joint up or down slightly to get the bolt inserted. Hand tighten the nut.
  • g) Tighten the upper and lower bolts
  • h) Tighten the two fender bolts.
  • i) Wire-tie the pig tails to the fender support bracket. Make sure you leave enough slack so as not to interfere  with the steering.
  • j) Connect the extension wire to the Halo Wheel and feed the extension wire along the A-Arm and up to the  maintenance access panel area
  • k) Repeat steps a) – i) for other side.
  • l) Verify LED lights work.
  • m) Tidy up the wires and reassemble Spyder.

Download a printable version with pictures

If you have any questions please contact Spyder Dan